A precision picatinny mounting rail for Tikka T3 and T3x rifles from Waters Rifleman, including both standard actions running plastic single stack mags and the CTR, UPR and Arctic models running steel mags.
- Precision cut from lightweight 7075 aluminium to Picatinny 1913 Mil Spec
- Stainless steel recoil pin - a key feature to retain position on Tikka actions - often neglected by other designs
- Matte black hard anodized Type III finish (as used on military AR receivers) - much more durable than the finish on other rails
- Comes with Torx 15 6/48 high tensile steel mounting screws
- 10mm low profile
Please note this low profile model is not suitable for use with the Tikka T3x TACT A1 which has full length high rails in two sections, it would be lower than the front section if fitted.
Available in three lengths:
- 165mm rail - standard size matching the action
- 195mm rail - extended for longer higher magnification scopes
- 235mm rail - extended for the longest scopes
Available in four MOA sizes in the extended size, with an incline built into the rail to aid scope travel at longer ranges.
- 0 MOA - for regular rifle and scope combinations
- 10 MOA - for distances out to 400yds
- 20 MOA - for distances out to 1000yds
- 30 MOA - for distances out to 1000yds and beyond
Please note the following sizes are currently only available for standard T3/T3x receivers running plastic mags:
- WR-2011 - Standard 165mm - 0 MOA - T3/T3x standard only
- WR-2031 - Extended 235mm - 20 MOA - T3/T3x standard only
Torque settings for fitting: 19-21 in-lb / 1.6-1.8 ft-lb / 2.25Nm